Garage door won't close: sensor repair in Simsbury

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (860) 735-5189

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Simsbury repairs the sensors and re-tests the opener's safety system.

Chain-drive garage door opener under exposed rafters

Doors that won't close in Simsbury

In West Simsbury and along the slope of Talcott Mountain, wooded lots and long driveways deliver leaves, pine needles and grit to the doorway, and they collect right where the sensors sit. In Weatogue and Terry's Plain, near the Farmington River, morning fog leaves condensation on the lenses, and the door may refuse to close until it clears. In Simsbury Center and Tariffville, older houses have detached garages or converted barns with wood jambs that move with the seasons. Farmington Valley winters also mean road salt and slush on the lenses for months. Wipe them, then check that both lights are steady.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Simsbury

  • Tariffville: The old mill village by the Farmington River gorge, with closer-set homes and small garages.
  • Terry's Plain: Farmland and older homes on the river plain north of the center.

See the full Simsbury service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (860) 735-5189
Call (860) 735-5189